Filter
Top Products
i
PREFACE
■ Using the Emulation Pod Safely
This manual contains important information regarding the safe use of the MB2145-507
emulation pod.
Be sure to read this manual before using the MB2145-507 emulation pod and use the emulation
pod only as described in this manual.
Read "Safety Warnings" at the beginning of this manual and make a careful safety check before
using the emulation pod.
Store this manual in a convenient place so that you can refer to it at any time while you are
using the emulation pod.
■ Objectives and intended readers
The MB2145-507 emulation pod is a development support tool for developing and evaluating
application products that use Fujitsu 16-bit microcontrollers, F
2
MC-16L/16LX/16F series
devices.
This manual explains how to handle and connect the MB2145-507 emulation pod. It is intended
for engineers who use the MB2145-507 emulation pod (hereafter "emulation pod") to develop
application products that use the F
2
MC-16L/16LX/16F series devices.
■ Product Environment
The emulation pod operates properly at a temperature of 5 to 45 and a humidity of 30% to
80%. Do not use in high-temperature and high-humidity environments or in any environment
where condensation will form.
Do not put heavy objects on the emulation pod. Since the cabinet is made of plastic, it may
break.
When power is turned on, keep the emulation pod away from items that can short-circuit or fire.
Keep the emulation pod on as level a surface as possible. Do not operate the emulation pod in
a location subject to severe vibration, dust, or explosive gases.
If the emulation pod is not used in the correct environment as described above, injury to the
user and nearby persons or damage to the emulation pod or other property may result.
Packing materials used to ship the emulation pod can be reused to transport the emulation pod
in the case of a failure. If possible, keep the packing materials.
■ Trademark
F
2
MC is the abbreviation of FUJITSU Flexible Microcontroller.
Other system and product names in this manual are trademarks of respective companies or
organizations.
The symbols
TM
and ® are sometimes omitted in this manual.