Filter
Top Products
Part # 1955203 (12/06) Page 13
6. Set cook time using the dial (factory preset at
30:00).
7. Press SET key – ready to cook.
8. Press START/CANCEL to begin manual cooking.
Manual cooking using Cook-N-Hold
1. Press the COOK/HOLD key, that key’s LED will
light.
2. Press SET key – TEMP LED will light.
3. Set cook temperature using the dial (factory preset
at 350°F).
4. Press Set key – HOLD LED will light.
5. Set hold temperature using the dial (factory preset
at 200°F).
6. Press SET key – FAN LED will light.
7. Select fan mode using one of the three (3) fan keys
(HIGH, LOW, PULSE) – the selected FAN LED
will light.
8. Press SET key – TIME LED will light.
9. Set cook time using the dial (factory preset at
30:00).
10. Press SET key – ready to cook
11. Press START/CANCEL to begin manual cooking.
Programming Product Keys (Master 475)
Note: Cooking time(s) is the element of the program that
tells the controller that other information (temperature,
fan speed, etc.) will be inputted into the controller. e
first step is to enter all the time periods required, followed
by the addition of the other cooking elements.
1. Press and hold PROG key for three (3) seconds – all
the product key LEDS light.
2. Code will be displayed. e controller is asking
for the access code. Press 4-2-7-5 and the
START/CANCEL key. PROD will be displayed
indicating you have gained access to Product
Programming.
OPERATING INSTRUCTIONS Continued
3. Press the product key (1-9) into which you want to
store a cooking program. SHLF will be displayed.
e control is asking if you want to program the
key as a shelf timer or with a cooking profile. Select
your answer by pressing the START/CANCEL
key. When the correct answer is displayed press the
SET key. e TIME LED will light. 30:00 will be
displayed.
4. Set first cook time using dial. If more than one
cooking profile is desired:
• Press the product key where the program is to
be stored (1-9) – PR-2 will be displayed.
• Set the second cook time using the dial (factory
presets for PR-2 through PR-5 are :00).
• Press the same product key (1-9 again – PR-3
will be displayed.
• Repeat the process for all profiles. When the last
profile time has been entered, press the SET key
OR
If less than five () profiles are desired press the SET key
after the last required profile – PRE will be displayed,
followed by :. e controller is asking if you would
like a reminder alarm (pre-alarm) to sound during the
cooking process (factory preset is :).
5. If a pre-alarm signal is desired – dial in the time
that the alarm is to sound. (Ex. If the product is to
be turned halfway through the 60 minute cooking
cycle, set the pre-alarm to 30 minutes. If pre-alarm
is not desired verify that “:00” is displayed. Press the
SET key – TEMP LED will light, and the display
will show the first profile cooking temperature
(factory preset to 350°F).
6 Set the first cooking temperature using the dial.
• Press the product key – PR-2 will be displayed
followed by the second temperature.
• Set the second cooking temperature using the
dial.
• Repeat as you did for cooking time, for all the
profiles desired.