Filter
Top Products
Part # 1844063 (08/06)Page 12
CLEANING
6. When the oven has reached the selected temperature,
experiment until you get the feel of the oven and the
speed of the bake. In case of some initial unevenness
in the baking, have patience for a few days until the
oven cures
Lighting/Shutdown Instructions
1. Open control panel door located on right hand side
of unit. To access combination gas control.
2. Turn gas cock on combination control to the “OFF”
position. Wait 5 minutes.
3. Turn gas cock on combination control to the
“PILOT” position.
4. Depress gas cock and light pilot burner.
5. Hold gas cock depressed for one minute after pilot
has been ignited, then release. Pilot should continue
to burn.
6. If pilot does not continue to burn after releasing
gas cock, repeat steps 2 thru 5 or have a qualified
serviceman check the system. Do not allow anyone
else to attempt repairs.
7. Once pilot is lit, turn gas cock to the “ON” position.
It is not necessary to repeat lighting procedure
unless the pilot is extinguished by any cause.
8. To shut down unit, turn gas cock on combination
control to the “OFF” position
Oven Exterior
Painted Surfaces should be cleaned when cool, using
a mild soap and warm water solution on a sponge or
soft clean cloth. Rinse and dry thoroughly with a soft
clean cloth.
Stainless Steel Surfaces usually respond to cleaning as
noted above. Stubborn stains or heat tint may require
the use of a commercial type cleaner, such as Penny
Brite or stainless steel pad. Always rub in the direction
of the polished lines. Rinse thoroughly with fresh water
and wipe dry.
Oven Interior
Aluminized Steel Surfaces Should be cleaned with a
damp soft cloth and mild household detergent.
Core Plates
CAUTION: e use of water to cool down or clean
core plates will void warranty.
To clean core plates, set thermostat dial to degrees
F ( degrees C) at the end of the cooking day and
allow thermostat to cycle for one hour. When the oven
has cooled, cooking residue will be carbonized and can
be removed by sweeping with a stiff brush. Stubborn
residue can be loosened with a scraper.
OPERATION Continued