Filter
Top Products
-.
.OW
to Set Oven for Cleaning
Quick Reminder:
1.
Press the AUTO SELF CLEAN pad.
2. Press the INCREASE
or
DECREASE pad
until the desired Clean Time appears.
—
If
the oven is too hot and
You
start to set
a
clean
cycle, the word “OFF”
wfil
appear in the display.
Allow
additional time
for
cooling before you try
to set the
cycle.
NOTE:
Only one oven at
a
time can be self-cleaned.
1.
Follow the directions in the Before
a
Clean
Cycle section.
(
L
AUTO SELF
CLEAN
A
2. After closing the door, press the
AUTO SELF CLEAN pad.
4
3. Press the INCREASE or
DECREASE pad until the
@\
desired Clean Time is displayed.
Clean Time is normally 3 hours.
v
You can change the Clean Time to
e
any time between 2 and 4 hours,
depending
on
the amount of soil
in your oven.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the
clean
cycle
is set. The words “ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK
light
goes off.
-—
4. When the LOCK light is off, open the door.
NOTE:
● The word “clean” will be displayed, the word
“DOOR” will flash
and
oven control will
signal
if you set the clean
cycle
and forget to close the
oven
door.
●
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
1
● You can find out when the
clean
cycle
STOP
will be finished by pressing the STOP
TIME
TIME pad.
To Stop a Clean Cycle
o
1.
Press the CLEAR/OFF pad.
2. When the LOCK light goes off and the oven
CLEAR
temperature has cooled below the locking
OFF
temperature, open the door.
(contitluell
ne.rt
pu,qe)
31