Filter
Top Products
OVEN CONTROL, CLOCK
Am
TMER
L .ck
To Set
the
Clock
The
clock
must be set for the automatic oven timing
functions to work properly. The time of day cannot be
changed during a Timed Baking or Self-Cleaning cycle.
(
1.
Press the CLOCK pad.
u
CLOCK
A
A
2. Press the INCREASE or DECREASE
pad to set the time of day.
@
3. Press the CLOCK pad to start.
~imer
To Set the Timer
“~he
timer does not control oven
❑
1. Press the TIMER
operations. The maximum setting
TIMER
ON/OFF pad.
on the timer is 9 hours and 55
ON/OFF
minutes.
A
A
2. Press the
INCREASE or
@
DECREASE pad to
set the amount of
time on the timer.
v
e
The timer will start automatically
within a few seconds of releasing the
INCREASE or DECREASE pad. The
timer, as you are setting it, will display
seconds until one minute is reached.
Then it will display minutes and
seconds until
60
minutes is reached.
After 60 minutes, it will display hours
(“HR” now appears in display) and
minutes until the maximum time of
9 hours and
55
minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed,
press the INCREASE or
Press
;nd
hold the TIMER ON/OFF pad
until
the
DECREASE
pad
until desired time is reached.
word “TIMER” disappears from the display.
If “TIMER” is not displayed,
press the TIMER
ON/OFF pad first, then follow the instructions above
(o
set the timer.
End
of Cycle Tone
Power Outage
The end of cycle tone is a series of three beeps
After a power outage, when power is restored, the
followed by one beep every six seconds.
[f
you would
display will flash and time shown will no longer be
like to remove the signal that beeps
every
six seconds,
correct-for example, after a 5-minute power
press and hold the CLEAR/OFF
uad
for
1()
seconds.
interruption the clock will be 5 minutes slow.
.
.—
eturn
the signal that beeps every six seconds,
The display flashes
until
the clock is reset. All other
.,s
and hold the CLEAR/OFF pad
for
10 seconds.
functions that were in operation when the power went
out
will
have to be programmed again.