Filter
Top Products
9
Section 2: Safety Guidelines
Positioning the Range
(fig 7)
1. When the range is fully assembled and the
gas line installed, insert the 240 volt plug
into the receptacle. Check that all nuts and
bolts have been tightened.
2. Ensure Teflon gliders and flooring are
clean and clear of all dirt and debris. (as
described in “Preparing the Installation
Site”)
8. If you are installing a 20” high profile
backguard:
a. Unpackage.
b. Secure 20” high profile back to the stove
top using:
3-large metal washers.
3-small metal washers.
3-stainless steel screws.
c. Secure back panel to the 20” high
profile back using:
9-black sheet metal screws.(do not secure t
he three bottom holes at this time)
d. Secure brackets (#3266-3 pcs.)to the 20”
high profile back and stove top,using 6 black
sheet metal screws.
(fig 7)
Push here
8. Range is now ready for gas connection by
a qualified technician/installer.
3. Caution. On flooring with very rough
surfaces or deep, large grooves the appli-
ance may have to be lifted and slowly slid
into position.
4. Place both hands on the front. Carefully
push the range into place. Do not forget to
plug in the main power cord before the
range is in it’s final position.
5. To level the range, simply adjust the
levelling screws located at the bottom of
each leg (as described “Preparing the
Range”). Using a 5/16” (8mm) open end
wrench, adjusting the screw clockwise to
raise up the corner, and counter-clockwise
to lower the corner. Do not forget that the
Teflon glider should extend beyond the
bottom of the leg by approximately 1/8”–
1/4” (0.3–0.6 cm).
6. Note: On soft kitchen flooring, the weight
of the stove may cause slight depressions
in the flooring. When the range is in
position and levelled, coasters may be
placed under the Teflon gliders of each leg
to protect the floor. Remove the coasters
when moving the range for cleaning or
servicing.
7. With range in position and assembled, now
is a good time to give unit an inspection
and cleaning. Remove all dirt and packag-
ing debris from the oven and around the
burners.