Filter
Top Products
38
only with the nut
driver supplied.
burner base
After the regulator has been converted the top
burner bases require conversion:
1)To expose the burner base, remove the
2) Find the 7 mm oriface removal tool, included
accept a standard slot screw driver to make the
oriface removal easier) Insert the tool inside the
in a safe place, in case you need to reconvert
later.)
the burner.
place in a clockwise motion.
Before proceeding with each step, check the
Follow the same procedure for the the rest of
the burners.
Adjusting the Simmer(Flame size)
After converting the burners with new orifaces the burner valves need to be
adjusted. The gas supply should be turned on for this step:
1) Remove the control knob only, the valve cover need not be removed.
2) Turn the burner on and set to low.
you are converting to.
inside the valve stem (see valve illustration).
4) Turn the screw driver clock wise to decrease, counter clock wise to increase
adjusted to low.
Each top burner contol will have to be adjusted. Replace the contol knobs
after you have completed the adjustments.
valve
valve stem
location of numbered size:
example shown matches with
natural gas.
7 mm nut driver
insert standard slot screwdiver here
When converting to LP (liquid propane)
down.
When converting to natural gas the