Hobart FT1000S-ER-BD Dishwasher User Manual


  Open as PDF
of 44
 
– 14 –
CHAMBER FLANGE AND BOLT ASSEMBLY AT EACH SECTION JOINT
Description Qty. Bolt Size Assembly Order
Instructions
Short Bolt-Use except
where long bolts or medium
bolts are required
22 ¼-20 x 5/8” [Bolt, Washer]
[Washer, Lockwasher,
Nut]
Use permagum on insides
of washers on both sides of
chamberanges.
Medium Bolt-Use for curtain
hangers and at top and
bottom corners of chambers
9 ¼-20 x 3/4” [Bolt, Washer]
[Washer, Lockwasher,
Nut]
Use permagum on insides of
washers at curtain hangers
andchamberanges.
Long Bolt-Use on saddle
joints, track/chamber
interface, and vertical frame
corner posts
15
¼-20 x 1”
[Bolt, Washer]
[Washer, Lockwasher,
Nut]
Use permagum on insides
of washers on both sides of
saddle joints and at tracks &
chamberanges.
Installing the Saddle Joint - Bottom of Chamber Flanges
1. Sealthetankendangeswheresectionsjointogetherusingasaddlejoint.
2. Positionthesaddlejointoverthetankendangesandmakesurethatallbolt
holes are aligned. Use drift pins (or punches) to align holes if required.
3. If machine is equipped with the standard type CC conveyor assembly, install
bafesalongwiththesaddlesusingsamemountinghardware.Ensurebafes
areadjustedtothelowestpositiontoensurethatthebafedoesnotinterfere
withtheightlinks(Fig.12).
SADDLE
JOINT
FLIGHT
LINKS
BAFFLE
Fig. 12
4. Boltthesaddlejointtothebottomtankangeswithsevenlongbolts,washers,
lock washers, and nuts provided.
5. Use Permagum on insides of washers on both sides to make an adequate seal
(Fig. 13). You may have to use a C-clamp on the saddle to get the hardware
started.
NOTE: Do not apply foam tape or permagum inside saddle or on surfaces
that the saddle covers.
 previous next