Hobart FT1000S-ER-BD Dishwasher User Manual


  Open as PDF
of 44
 
– 7 –
7. Remove any packaging, tape, wire and bracing from each section. Remove all
rear and lower panels.
8. Verifythatshippingtapehasbeenremovedfromalloatsineachtankandthat
theoatsarefreetooperateproperly.
NOTE: Do no throw out any loose parts. These may be required for installation
or operation.
LOCATION
Allow adequate space for machine installation and operation. Place the machine
sectionsclosetotheirnalposition.Allowspacetoworkontheendsofthecenter
section.
Review, but do not remove tags or labels. Remove tags after installation is complete
Positioning the Center Section
Useachalklineontheoortoalignthemachinealongitscompletelength.
Witheachsectioninitsapproximatenalposition,determinewhichsectionisatthe
highpointintheoor.Machine assembly begins after the center section has
been leveled to a height that compensates for the oor height of the other
sections.
Leveling the Center Section
Leveling is an important installation function because it could affect door operation
and cause leaks once the machine is operating.
• Level the center section along its length by opening the doors and placing a
level between the doors along the tank support rail (Fig. 2). Do not check level
on top of doors. Adjust the feet in or out as required to level.
Fig. 2
 previous next