Hobart FT1000S-ER-BD Dishwasher User Manual


  Open as PDF
of 44
 
– 32 –
• Removetheconveyorrollerfromoneendofthelastconveyorrodontherst
section. Then pull the conveyor rod out and save the roller and washers for re-
assembly. To join the sections, thread the rod back through the side bars and
washerandthenthroughtheightlinks,alternatingthelinksfromtherstand
second sections, and then through the washer and side bars on the opposite side.
Complete the assembly by attaching the conveyor roller with a new retaining ring
(Figs. 34 & 35). Spin the roller to ensure that the retaining ring has been secured
to the conveyor rod. Always use a new retaining ring to secure a tight grip on the
conveyor rod. Repeat this step for joining each succeeding conveyor section.
Fig. 34
Fig. 35
Pull the conveyor through the machine starting at the load end, around the freed
conveyor sprockets at the unload end, down to the top of the lower track and back
through the machine. Make sure conveyor rollers do not feed under tracks.
Jointheendsoftheconveyorbythreadingthenalconveyorrodthroughbothrows
ofightlinksandthesidebarsonbothsides.Conveyorlinksalternatewithboth
ends of the link on the inside following by both ends of the next link on the outside,
except for the conveyor offset link, which is only used on the standard conveyor.
 previous next