Filter
Top Products
– 22 –
REAR PANEL
TOP PANEL
FRONT PANEL
Fig. 24
2. Install one of the blower assemblies on top of the heater housing by lowering
the blower assembly on an angle so that the front tabs hook underneath the
notches on the top plate of the heater housing (Fig. 25 and 26).
BLOWER
ASSEMBLY
NOTCH
FRONT TAB
FRONT TAB
NOTCH
Fig. 25 Fig. 26
3. Lower the back side of the blower assembly down so that the holes in the blower
mounting brackets line up with the holes in the support brackets on the heater
housing (Fig. 27).
4. Install ¼-20 hex head cap screws with washers and stop nuts as shown in Fig.
27 and tighten
SUPPORT
BRACKET
BLOWER
MOUNTING
BRACKET
Fig. 27