Filter
Top Products
– 11 –
Positioning Hood Filters
The three hood filters must be in their proper positions or your appliance will not function. Figure 15
shows the long, welded pins (three on the right and three on the left) against which the filters rest.
Directly behind the pins on the left side are three shorter filter actuator switch pins that push in and out.
Place each filter so that it pushes its filter actuator switch pin in, or your appliance will not operate.
Fig. 15
Fig. 16
Remove the plastic cover from the charcoal filter. The charcoal filter goes to the rear of the hood. Make
certain it is pulled downward to engage the actuator of the interlock switch. Notice (Fig. 16) that the
actuator pin is pushed in and the filter is resting against the last set of welded pins.
PL-40086-1
WELDED PINS
GREASE FILTER
ACTUATOR PIN
AIR FILTER
ACTUATOR PIN
CHARCOAL FILTER
ACTUATOR PIN
PL-40087-1
CHARCOAL FILTER ACTUATOR PIN
CHARCOAL
FILTER