Filter
Top Products
– 15 –
REPROGRAMMING SET TEMPERATURE AND/OR TIME
Any of the program keys may be reprogrammed if a different time or temperature is desired.
ACTION
1. Enter Program Mode
•
Press both Keys 3 (Up) and 6 (Down), and hold for 2 seconds.
• Key 1 is already programmed for fresh chicken, so press
Key 3 (Up) to change display.
2. Change Temperature
• Press Key 1 tells controller you are changing temp.
• Press Key 1 (Edit) a second time.
• Hold Key 3 (Up) or Key 6 (Down) to set temperature.
• Press Key 2 (Enter) to save the setting.
3. Change Time
• Press Key 3 (Up) tells controller you are changing time.
• Press Key 1 (Edit) and set the desired cooking time for
Menu Item 2; for example, 19 minutes for frozen chicken.
• Hold Key 3 (Up) or Key 6 (Down) until the display reads
19:00.
• Press Key 2 (Enter) to save the setting.
4. Exit Programming Mode
• Press and hold Key 4 (Exit) until the display screen blanks.
This exits the programming mode and returns the controller
to normal operating mode.
DISPLAY SHOWS
M 1 (Menu Number 1)
M 2 (Menu Number 2)
StPt 1 (Setpoint 1),
alternating with 32°F
Temperature selection
Temperature selection
tinE 1 (Time 1),
alternating with :00
Time selection
19:00
19:00
Blank
idLE (Idle)
The controller memory will remember only the last figures programmed under any key. Turning the
fryer off, or any other power interruptions, will not affect the controller settings last saved into memory.
If a program key with no preprogrammed cooking time is pressed, the controller will not respond. The
display will continue to show idLE until a programmed key is selected.
Any program, once initiated, can be cancelled by pressing and holding the lighted program key until
the light on the key extinguishes.
In the event of a program malfunction or error message, turn the power switch OFF, pause for
10
seconds, then turn power switch ON. The display should read prE-HEAt, and the red heat light will
glow if the oil has cooled. If the error message reappears, contact your local Hobart service office.