Filter
Top Products
.—...-.._..%...m,______”__”_
,
,——————
‘i’
>-
[
E~~ iemove the rack from the pan.
Y~3YCarefully pour out the grease in the
pan into-a‘propercontainer.Wash
and rinse the broilerpan and rack
in hot, soapy water.
If food has burned on, sprinklethe
rack with detergent while hot and
cover with wet paper towels or a
dishcloth.That way, burned-on
foods will soak loose while the
meal is being served.
Do not store a soiled broiler
pan and rack in the oven.
Oveashelves
~otl may clem theoven shelveswith
a mild abrasivecleanser,following
manufacturer’sdirections. After
cleaning, rinse the shelves with
clean water and dry with a dry
cloth. To remove heavy, burned-on
soil, you may use soapy metal
pads, following manufacturer’s
directions. After scrubbing, wash
with soapy water, rinse and dry.
ovenBottom
The @veEnbottom has a porceIaiRR
enan~elfinish. To make cleaning
easier, protect the oven bottom
from excessive spillovers.This is
particularly importantwhen baking
a fruit pie or other foods with a
high acid content.Hot fruit fillings
or other foodsthat are highly
acidic (such as milk, tomatoesor
sauerkraut, and sauces with
vinegar or lemonjuice) may cause
pitting and darnageto the porcelain
enamel surface.
If a spilloverdoesoccuron the
oven bottom, allow theoven to cool
first. Youcan then clean the oven
bottom with soap and water, a mild
abrasivecleanser or soap-filled
abrasivepads.
~Rinse well to remove any soap
before self-cleaning.
(on modelssoequipped)
CAUTION: Before replacing
your oven bulb, disconnect
electrical power to the range at
the main fuse or circuitbreaker
cover and bulb ‘coolCompletelya
me oven lamp (bulb)is covered
with a removableglass cover that
is held in place with a bail-shaped
wire. Remove oven door, if
desired, to reach cover easily.
To remove:
1. Hold hand under cover so it
doesn’t fall when released. With
fingers of same hand, firmly push
back wire bail until it clears cover.
Lift off cover. DO NOT REMOVE
NY SC~WS TO WMOVE
COVER.
2. Replacebulbwitha 40-watt
householdappliancebulb.
To replace Cover:
1. Place it into grooveof lam~3
receptacle. Pull wire bail forward
to center of cover until it snaps into
place. When in place, wire holds
cover firmly.Be certain wire bai~is
in depression in center of cover.
2. Connectelectricalpowerto
therange.
(coiltitzl(ed flext page,
———
——
———
.
.-
I
——
-