Filter
Top Products
I
EQMi9VE~~flTMSM.L~BBUSMERS(continued)
Ifwires were disconnectedto remove the
cooktop,feedwires through the burner holes in
the cooktop.Attachto each burner electrode
terminalcarefully,makingsure not to bend the
terminal.Then lowercooktopuntilit snaps
overthe clips.
Electrode
Tall Screw
~~
—-----: /
7. Carefullyinsert burner bases straight down
with the tube over the orificespud. Replacethe
screws, ~nating sure tie M screw is oppositi
tie burner electiode h each bwner base.
1. Liftcooktop.
2. Liftburner
assemblies
straight up and
set aside to gain
access to stlrface
burner spuds.
~.
With a 5/16”
wrench, reinove
each of the fo[~r
SilL[dS011the
sL~rff~~ebllrner
gas inlet tubes
2. Locatethe thermostat
adjustment screw at left of
thermostat shaft.Turn
screw clockwiseuntilthe
smallpointer is at LPor N,
depending on the typeof
gas you are convertingto.
3. Replaceovencontrolknob.
❑ COHVERTTHEOWEHBURHEBoRiFicEs
Owen
surn@F
1. Removeoven door,storage drawer or broiler
drawer, oven bottom and burner baffle.The lower
burner ofi~ce spud is located behind the storage
drawer, broiier drawer or kick panel. (On some
models, a metal shield must be removed to access
theortice.)
2. To convert to w gas,
use a 1/211wrench to turn
the lowerburner orifice
spud clockwise.Tighten th
spud onlyuntilit is snug.
To prevent Ieakage, do
not overtighten the spud.
TOCOnVertto natird gas, loosen the spud
about 2 turns.
~~~i!BwrHsY(on models so equipped)
To Convert to ~ ~as9use a 1/211wrench to turn
the upper burner oltice spud clockwise.Tighten
spud only until it is snug with the base. To prevent
leakage, do not overtighten spud.
TO eonwert $0 natid gas9 loosen tl]e spud
about 2 turns.