The grill consists of two black grill grates and a grill burner. Only install the grill on the
left side of your range.
To Install Grill Module
1. Before installing grill components, be certain control knobs are in the Off position.
2. Position the grill burner with mixer tube openings toward the orifices. Slide the
burner towards the orifices until the igniter is in between front and rear grill sections.
Lower into place until side openings are resting on the burner support pins.
3. Place the grill grates on the top of the rangetop.
NOTE: Before using the grill for the first time, heat the E-ven HeatTM grill burner to
remove the protective shipping coating. Heat the grill on Hi for 10 minutes and
use the vent system to remove any additional smoke during cooling.
To Remove Grill Module
1. Be sure control knobs are in the Off position. Remove grill components once they
are cool.
2. Remove grill grates.
3. Lift the grill burner up off the support pins about 2 inches. Slide the burner away
from the orifices.
17