Filter
Top Products
Air Shutter Adjustment
To adjust surface burner air
shutters:
SURFACE BURNER ROTATE AIR
Loosen fastening screw with a phillips screw _ AIRSHUTTER SHUTTERON
driver and rotate air shutter to increase or _ _ MfXERHEADTO
_ SCREW MAKE AIR
decrease the size of the air opening. As the "_'_L. _\_J_..\ ADJUSTMENT
shutter is turned observe change in flame _,,_- A_BSHUTrEB
appearance. Adjustment is satisfactory
when a clearly defined, even blue flame A'ROPEN'NG-/'_70('_L_._,TO
results at the Hi flame setting. After orOeN_J'cL°sE
adjustment, tighten screw.
To adjust grill burner air
shutters:
The left hand air shutter controls the rear
half of the grill burner. The right hand shutter "_. GRILLBURNERAIRSHUTTER
controls the front half. _ _o_--'_,
Slide air shutter backward or forward to __"_s_
increase or decrease the size of the air open- A_ROPEN_NG"_"_'_ "-Z._
A,BSHOT ER
ing. Air shutters fit snugly on the grill burner, INSERTSCREWDRIVERBLADE
IN SLOT AND TWIST WITH
so a screwdriver blade may be required to SLIGHTPBESSURETOALLOW
make this adjustment. Observe change in AIRSHUTTERTOSLIDEEASILY.
flame appearance as the air shutter is moved.
Adjustment is satisfactory when a clearly
defined, even blue flame results at the Hi
flame setting. The snug fit of the air shutter
assures it will remain positioned correctly.
On any burner, closing the air shutter too
far will cause the flame to become soft and
yellow tipped. Opening the air shutter too
wide will cause the flame to blow away from
the burner ports. Proper adjustment will pro- -,..._
duce a sharp, clearly defined, even, blue
flame.
Lo Flame Adjustment
This appliance has been shipped from the factory with Lo and Med flame settings
adjusted for use with natural gas and average installations. There is a wide variety
of conditions caused by altitude and gas mixtures controlled by utility companies,
which will vary and affect the gas flame and performance. Adjustments should be
made at time of installation. If conditions change, follow the procedures outlined
to adjust the Lo setting.
10