Filter
Top Products
Surface Controls
To Set Controls
• Since the controls are a push-turn type, they must be pushed down before
turning. To set (from the OFF position), push down on control knob and imme-
diately turn counterclockwise to the MTE position until burner ignites. After
ignition, turn knob clockwise to desired setting.
• Igniter will continue to spark until knob is turned clockwise back to or past
Hi position on knob.
Control Locations NOTE: When using an AG200 surface
burner assembly with control
1. Left rear surface burner or grill locations #1 and #2, the control
2. Left front surface burner or grill knob may be turned to a
3. Right rear surface burner position lower than the Lo
4. Right front surface burner setting. (The I.o detent is set
for the grill burner.)
1. 2. 3. 4.
Suggested Control Settings
for Surface Burners
The size and type of cookware and the amount and type of food being cooke
will influence the setting needed for best cooking results. The setting indicate(z--
should serve as a guide while you become familiar with your cooktop.
Use the Hi flame setting to quickly bring __
foods to a boil or to begin a cooking opera- _,(_t_)_.,_(_(fi_)
tion. Then reduce to a lower setting to con- _._.v,,._,_._"
tinue cooking. Never leave food unattended
over a Hi flame setting.
Med setting is used to continue a cooking
operation. Food will not cook any faster f _
when a Hi flame setting is used than that _,,,_
needed to maintain a gentle boil. Remember,
water boils at the same temperature whether
boiling gently or vigorously.
Use Lo setting to keep food at serving
temperatures without further cooking. You _ _
may find that some cooking may take place
if the cookware is covered. _.__
14