Filter
Top Products
Surface BurnerModule
To hnstall IBurner Module
1. Be sure control knobs are turned off.
2. If the grill burner and grill grates are in place, remove before installing a surface
burner module. Clean burner basin of any grease accumulation. (See page 21 fc
cleaning recommendations.) .._.
3. Position the burner assembly with the mixer tube openings toward the orifices. Slide
the burner assembly toward the orifices until opening for igniter is over the igniter.
Lower into place until side openings are resting on the burner supports and igniter
is centered between the two flash tubes.
4. Install the aeration tray by inserting the prong at the end of the pan into the opening
in the end of the burner basin. Lower the opposite end into the range top.
To Rcn.ove Burner Module
1. Control knobs should be in the OFF position and the range top should be cool.
2. Remove the aeration tray by lifting up the front end on the right side (back end on
the left side) until the top clears the opening of the range top by about 5 inches.
3. Hold aeration tray by the sides and slide away to remove the prong from the opening
and clear the surface burners.
4. Lift up on the sides of the surface burner assembly bracket about 2 inches. Slide
away from the orifices.
5. A storage tray, Model AG350, is available and can be used for storing a surface burner
module.
Note: Optional surface burner assembly, Model AG200, can replace the grill burner
assembly. Model AG200 air shutters have been adjusted for compatibility on
the left side.
l Note: Do not disassemble the surface burner assembly.
16