Jenn-Air SEG196 Range User Manual


 
24. CAUTION -- Do not store items of interest to children in
cabinets above range -- children climbing on the range
,._ to reach items could be seriously injured.
25. Do not touch grill and surface burner areas, perimeter trim
around cooktop or interior surfaces of oven. During and
after use, these areas may be hot enough to cause burns.
Avoid contact with these areas by clothing or other
flammable materials until they have had sufficient time to
cool. Other surfaces may become hot enough to cause
burns -- among these surfaces are the upper door frame
and glass, oven vent opening and surfaces near the opening,
and the top edge of the control panel.
26. Use care when opening oven door. Let hot air or steam
escape before removing or replacing food.
27. Do not heat unopened food containers. Build-up of pressure
may cause container to burst and result in injury.
28. Always place oven racks in desired location while oven
is cool. If rack must be moved while oven is hot, do not
let potholder contact hot heating element in oven.
29. Do not clean door gasket. The door gasket is essential
for a good seal. Care should be taken not to rub, damage
or move the gasket.
30. Do not use oven cleaners. No commercial oven cleaner
or oven liner protective coating of any kind should be used
in or around any part of the oven.
31. Clean only parts listed in this manual and use procedures
recommended.
32. CAUTION: BEFORE SELF-CLEANING THE OVEN,
"-_ REMOVE BROILER PAN, FOOD, AND OTHER UTENSILS.
33. Always remove soiled broiler pan from the broiler
compartment after cooking for grease left in the pan may
become hot enough to ignite.
34. Listen for fan. A fan noise should be heard during the broil
and cleaning cycles, if not, call a serviceman before self-
cleaning again.
35. Before servicing your appliance, disconnect power to the
range at the main fuse or circuit breaker panel and at the
electrical receptacle.
36. Do not allow aluminum foil or meat probes to contact
heating elements.
37. WARNING: To reduce the risk of tipping of the appliance,
the appliance must be secured by properly installed anti-
tip devices. To check if devices are installed properly,
remove the access panel and verify that the anti-tip devices
are engaged.