Filter
Top Products
10
Using and Caring for Your Cooktop
wWARNING
Fire Hazard
Do not let the burner flame extend
beyond the edge of the pan.
Turn off all controls when not
cooking.
Failure to follow these instructions
can result in death or fire.
Using the surface burners:
Control knobs
1. Grasp the control knob.
2. Push down and turn to HI. The electric
spark ignitor will ignite the gas flowing into
the burner. When you hear a clicking
sound, you know that the ignitors are
working. Gas is flowing as long as knob is
not set at OFF.
3. When the burner is lit, turn the control
knob to the desired flame setting. (See the
guide under “Burner heat settings” later in
this section.) You can turn the knobs to
any of the marked settings. The ignitor will
turn off and the clicking will stop when the
burner ignites.
NOTES:
• The ignitors may click a number of times
before burner lights. This is normal.
• All four burner ignitors will spark
regardless of which burner you are using.
• Visually check that the burner has lit. If the
burner does not ignite, listen for the clicking
sound. If you do not hear the ignitor click,
TURN THE BURNER OFF. Check that the
service cord is placed firmly in the wall
receptacle. Check for a tripped circuit
breaker or blown fuse.
Check that the control knob is pressed
completely down on valve shaft. If the spark
ignitor still fails to operate, call your
nearest designated service outlet.
Proper grounding and polarity are
necessary for correct operation of the electric
ignition system. If the wall receptacle does
not provide correct polarity, the ignitor will
become grounded and click every once in
a while, even after the burner has ignited.
A qualified electrician should check the wall
receptacle to see if it is wired with correct
polarity.
Burner heat settings
Use correct burner heat settings (see chart
later in this section). If the heat setting is too
high, it can:
• Char bacon and cause curling.
• Make eggs tough and crisp at the edges.
• Toughen liver, fish, and seafood.
• Scorch delicate sauces and custards.
• Cause a boilover.
OFF
REAR
REAR
H
I
M
E
D
L
O
Until you get used to the settings, use
the following as a guide.
SETTING
HI
• To start food cooking.
• To bring liquid to a boil.
Between
MED and
HI
• To hold a rapid boil.
• To quickly brown or
sear meat.
MED
• To maintain a slow boil.
• To fry poultry or meat.
• To make pudding, sauce,
or gravy.
Between
MED and
LO
• To stew or steam food.
LO
• To simmer food.
• To keep food warm.
RECOMMENDED USE
• To melt chocolate or butter.
9753310Av15(c70) 12/4/98 10:36 AM Page 10