Filter
Top Products
©2004 Maytag Services 16023522 C–7
Conversion Instructions (Model CPR1100AD*)
Range Adjustments
Top Section - Gas Top Pilot Adjustment
Seefigure5.
Purge all air from supply system by turning on one top
burner valve. Then turn off valve and adjust top pilot
flame using adjusting screw “A” (figure 5) so that flame is
even with top of flash tube. To light the burner, push and
turn top burner knob to the lite position.
Air Shutter - Oven Burner
a. The approximate length of the flame of oven burner is
a1/2² distinct inner blue flame (see figure 7).
b. Oven burner flame can be checked as follows:
1. Yellow flame on burner - open air shutter to the
widest opening that will not cause the flame to lift or
blow off the burner when cold. (See figure 8).
2. Distinct blue flame but lifting - close burner air
shutter to the point where it will not cause the flame
to lift or blow off the burner when cold. (See figure
8).
c. The oven burner air shutter adjustment is the same on
ranges with a gas pilot or electric ignition.
FIGURE 5
Conventional Burners
FIGURE 6
FIGURE 7
FIGURE 8
1/2²FLAME
INNER CONE
3/4²FLAME
ORIFICE
HOOD
AIR
SHUTTER
Top Section - Electric Ignition
To operate, push and turn burner knob to the LITE
position. The top burner will light. To turn OFF spark after
the top burner has ignited turn knob to HI setting.
Top Burner Adjustment
All Top Burner Valves:
The approximate height of the flame at the high or full-on
position is shown below. Adjust burner air shutter (figure
6) to the widest opening that will not cause the flame to lift
or blow off the burner when cold.
TOP OF FLASH TUBE
LOCK SCREW
ORIFICE HOOD
AIR SHUTTER