Filter
Top Products
4. Re-setting all parameter
changes back to the factory
settings.
^
Turn the programme selector to STOP
f.
^
Switch off the machine.
^
Press and hold ß and 6 at the
same time, and whilst doing so,
switch the machine on with the I-0
button.
The current programme status "P..."
will appear in the display and the p /
6 indicator light will come on.
^ Press 0 as often as necessary or
hold it pressed in until E33
(programming level 33) appears in
the display.
^ Turn the programme selector to any
switch position (except STOP).
00 or PP will appear in the display.
00 = factory setting
(Electronics have not been
re-programmed).
PP = Electronics have been
re-programmed.
^
If PP is displayed, press ß to
change from PP to 00.
^
Press 6. SP appears.
^
Press 6 again. All values which had
been changed have now been now
reset to the factory settings.
When restoring all changed
values, please note
that any new setting for the water
hardness level also reverts to the
factory setting of 19 °d (3.4 mmol/l).
The final rinse temperature of
85°C/1’ is now 93°C/3’.
Re-setting is required in both cases.
Programming special functions
38