Filter
Top Products
Position and secure the machine
To ensure stability the machine must
first be aligned and then screwed to the
worktop.
^
Open the door. Secure the machine
to the front edge of the worktop using
screws through the holes on the left
and right hand sides of the front trim.
^
Do not use silicone sealant to seal
the gaps between the machine and
any neighbouring units as this would
hinder ventilation to the circulation
pump.
Depending on the requirements for
building under, the following kit
can be
ordered from the Miele Spares Dept.:
Cover plate (protects the worktop)
The underside of the worktop is
protected against water damage by a
stainless steel plate.
Decor frame and decor panel
(optional)
If you wish to fit a decor panel to the
machine this can only be done by a
Miele Service technician. Contact Miele
for details.
Decor panel dimensions:
Door panel H x W: 442/586 mm
Service panel H x W: 117/586 mm
Installation
46