Filter
Top Products
Please refer to the installation
diagram supplied with the machine.
,
Furniture and fittings installed
near the machine must be of a
commercial standard able to
withstand the effects of steam and
condensed water.
The machine must be installed correctly
and levelled.
Any unevenness in the floor level can
be compensated for and the height of
the machine raised or lowered by
adjusting the four screw feet.
The machine can be installed in the
following ways:
^ Free-standing.
^ Slot-in or at the end of a row:
The machine can be installed next to
other machines or furniture or in a
suitable niche. The niche must be at
least 60 cm wide and 60 cm deep.
^
Built-under:
The machine can be installed under a
continuous worktop or sink drainer.
The recess must be at least 60 cm
wide, 60 cm deep and 82 cm high.
If necessary, the machine lid can be
removed as follows:
^
Open the door.
^ Remove the fixing screws on the left
and right hand sides using a cross
slotted screwdriver.
^ Pull the machine lid approx. 5 mm
forwards, lift it upwards and remove
it.
Important for machines fitted with a
steam condenser (depending on mo
-
del):
To prevent damage by steam to the
worktop, the self adhesive protective
foil supplied (25 x 58 cm) must be
stuck in place underneath the worktop
near the steam condenser.
Installation
45