Filter
Top Products
Program sequence indicator
lights (16)
Once a program has been started the
program sequence indicator lights (16)
show which stage of a program is cur
-
rently in progress.
Time display (15)
The running time of the program se
-
lected shows in the time display (15) in
hours and minutes before a program is
started. During a program the time left
until the end of the program is dis
-
played. The “Time Left” indicator light
next to the time display lights.
The time displayed for a program may
vary. This is because of the water inlet
temperature at each intake and be-
cause of the load size being washed.
When the dishwasher is turned on the
display shows an average time for a
cold water intake.
Times shown in the program chart refer
to normal loads and average tempera
-
tures and are for guidance only.
Each time a program is run the elec
-
tronic unit takes into account the new
conditions and calculates the program
time required. This new figure is then
displayed.
Light ring (18)
The light ring illuminates when the dish
-
washer is turned on and goes out at the
end of a program.
It will come on again if the program se
-
lector is turned to “Stop” or the door is
opened and then closed again.
If the “Delay Start” function is activated
the light ring will go out 10 minutes after
you have set the delay start time.
It will come on again for 10 minutes if a
button on the control panel is pressed
or if the program selector is moved dur
-
ing this delay period.
Operating the dishwasher
32