Filter
Top Products
Problem Possible cause Remedy
A whistling noise is
heard during the pro
-
gram
The circulation pump seal
sometimes makes a whis
-
tling noise. This may be
caused by the detergent.
This is not a problem. Try
other detergents. Consult
the Miele Technical Ser
-
vice Department if the
noise is persistent.
Knocking noise in the
water pipes
This may be caused by
the installation or the or
the piping.
This has no affect on
dishwasher. If in doubt
contact a plumber.
Three horizontal bars
show in the time display
at the end of the pro
-
gram:
– – –
There may be a technical
fault.
–
Turn the program se
-
lector to the “Stop” po
-
sition.
–
Turn off the dishwasher
using the “On/Off” but
-
ton.
After a few seconds:
– Turn the dishwasher on
using the “On/Off” but-
ton.
– Turn the Program se-
lector to the desired
program.
– Press the “Start” but-
ton.
If the three horizontal bars
appear again at the end
of the program, there is a
technical fault.
–
Call the Miele Techni
-
cal Service Depart
-
ment.
Despite the problem the
dishwasher can be used
in all programs but, the
water will not heat. The
“Energy Saver” program
only works if the dish
-
washer is connected to a
hot water supply.
Problem solving guide
47