Filter
Top Products
Problem Possible cause Remedy
The indicator light
“Intake/Drain” is flash
-
ing shortly after the
program has started
The water valve is closed. Open the water valve
completely.
If the program still does
not start:
–
Turn the program se
-
lector to the “Stop” po
-
sition.
–
Turn the dishwasher off
using the “On/Off” but
-
ton.
–
Start the program
again.
The water pressure at the
intake is lower than 5 psi
(0.3 bar).
Call a plumber.
The water inlet filter is
blocked.
Before fixing the problem
you must:
– Turn the program se-
lector to the “Stop”
position.
– Turn the dishwasher
off using the “On/Off”
button.
–
Check the water inlet
filter and clean if
necessary.
The indicator light
“Intake/Drain” comes on
during the “Energy
Saver” program
The incoming water has
not reached the minimum
required temperature of
115° F (45 °C), the hot
water system may be
overloaded (see “Pro
-
gram selection”).
–
Start the program
again.
–
If the indicator light
comes on again select
a different program.
Problem solving guide
45