Filter
Top Products
32
Limiters
Be absolutely sure to set the limiters (travel range) of the pan/tilt head before use.
Depending on where the pan/tilt head system has been installed, obstacles may be
present within the travel range with which the camera may come into contact.
Contact with any such obstacle by the camera may cause malfunctioning or
accidents.
In this case, contact can be prevented by setting the limiters directly before any such
obstacle.
Multi function controller (AW-RP655) is used to set the limiters.
The positions of four limiters — namely, the upper, lower, left-most and right-most
limits of the travel range — can be set.
Once they have been set, the positions will not be lost even after the power has been
turned off.
Setting the limiters
• Setting the upper limit of operating range
1. Operate the controller, and turn the camera to the
position which will serve as the upper limit.
2. While holding down the OK button on the controller,
press TRACING/PRESET MEMORY button 47
.
3. The setting is completed when TRACING/PRESET
MEMORY button 41 [LIMIT ON] lights.
4. Operate the controller, and check that the upper limit has
been set properly.
• Setting the lower limit of operating range
1. Operate the controller, and turn the camera to the
position which will serve as the lower limit.
2. While holding down the OK button on the controller,
press TRACING/PRESET MEMORY button 46
.
3. The setting is completed when TRACING/PRESET
MEMORY button 41 [LIMIT ON] lights.
4. Operate the controller, and check that the lower limit has
been set properly.
• Setting the left-most limit of operating range
1. Operate the controller, and turn the camera to the
position which will serve as the left-most limit.
2. While holding down the OK button on the controller,
press TRACING/PRESET MEMORY button 44
.
3. The setting is completed when TRACING/PRESET
MEMORY button 41 [LIMIT ON] lights.
4. Operate the controller, and check that the left-most limit
has been set properly.
• Setting the right-most limit of operating range
1. Operate the controller, and turn the camera to the
position which will serve as the right-most limit.
2. While holding down the OK button on the controller,
press TRACING/PRESET MEMORY button 45
.
3. The setting is completed when TRACING/PRESET
MEMORY button 41 [LIMIT ON] lights.
4. Operate the controller, and check that the right-most limit
has been set properly.