Filter
Top Products
Solstice I12+ Cooking Computer for ROV Fryers
Pitco P/N 60149517 & 60149518
Page 19 of 44 L22-378 Rev 3
6.2.2 Shake Time:
Shake time is an alarm that sounds during Cook Time to prompt operators to shake the basket.
Default for this value is zero, meaning the Shake Time is inactive. To use Shake Time, the time
value must be a non-zero value, and, must be set to a value less than cook time.
Display shows [SHn mm:ss] where “n” is the key number, “SH” means Shake, and “mm:ss”
is time in minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the key to
save shake time and continue setup for this product key.
Note: The value entered for shake time is the time from the end of the cook.
6.2.3 Hold Time:
Cooked product may stand in holding bins for a period of time. This timer produces an alarm to
inform operators to discard old product and start a new cook. Default for this value is zero,
meaning the Hold Time is inactive.
Display is showing [HDn mm:ss], where “n” is the key number, “HD” means HOLD, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the key to
save hold time and continue setup for this product key.
6.2.4 Hold Pre-Alarm:
Hold Pre-Alarm is a timer setting that is used to warn operators that the Hold Time is about to
expire. To use Hold Pre-Alarm, the time value must be a non-zero value, and, must be set to a
value less than Hold Time. Default value is zero, meaning the Hold Pre-Alarm is inactive.
Display is showing [PAn mm:ss] where “n” is the key number, “PA” means Pre-Alarm, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the key to
save pre-alarm time.
Note: Value entered for hold pre-alarm time is the time from the end of the hold period.
Display will again return to . Repeat steps from section
2.2.2 to make changes to any other product keys or continue.
6.3 To Exit Level 1 programming:
Display shows .
Press the key. Display shows . Continue to section 3 “To Change Options”,
or, exit here in the next step.
To exit Level 1 programming, press the key again.
Displays will show , , or , when no active cooks are
running.