Filter
Top Products
PROBLEM
Burner fails to
light
POSSIBLE CAUSE
SOLUTION
The power cord is not
Plug the power cord into a live circuit
plugged into a live circuit with
with proper voltage. (See Installation
proper voltage. Instructions.)
A household fuse has blown
Replace household fuse or reset
or a circuit breaker has
circuit breaker. In case of prolonged
tripped.
power failure, manually light burners
(see page 8).
Burner ports are clogged.
Clean with a straight pin (see pages
24 and 26).
Burner flames
are uneven
Burner ports are clogged.
Clean with a straight pin (see pages
24 and 26). If this fails, call an
authorized Roper service technician
for service.
Burner flames
Air/gas mixture is incorrect.
Contact an authorized Roper service
lift off ports, are
technician to check air/gas mixture.
yellow, or are
noisy when
turned off
Burner makes Burner is wet from washing. Let dry.
popping noise
when on
Control knob(s) You are not pushing in before
Push control knob(s) in before turning
will not turn
turning.
to a setting.
Self-Cleaning
The Oven Selector and Oven
Set both the Oven Selector and Oven
cycle will not Temperature Control are not
Temperature Control to CLEAN.
operate
set to CLEAN.
The range clock does not Reset clock to show the correct time
show the correct time of day. of day. (See page 11.)
The Lock Lever is not in the
Move Lock Lever all the way to the
CLEAN position-all the way right.
to the right.
The Start Time Dial does not
Reset the Start Time Knob to show
show the correct time of day the correct time of day. Pull knob out
or the knob is not all the way all the way.
out.
The Stop Time Dial is not set
See Step 3 in “Setting the controls”
ahead to the time you want
on page 21 for proper setting instruc-
the self-cleaning cycle to stop. tions.
continued
on next
page
29