Sears Refrigerator Refrigerator User Manual


 
Using the ice and water dispensers (cont.)
The ice dispenser (cont.)
To dispense ice:
Select CUBED or CRUSHED (if available) by
moving the Ice Selector Switch to the desired
setting.
Press a sturdy glass against the ice dispenser
bar. Be sure to hold the glass close to the
dispenser opening so ice does not fall outside of
the glass.
Remove the glass to stop dispensing.
If you need a large amount of ice, take it directly
from the ice bin in the freezer. Do not use the
dispenser. (See "The dispenser arm has been
held in too long" on page 31 .)
NOTE: The dispenser will not operate when the
freezer door is open. The first few batches of ice
have an off-flavor due to the new plumbing and
parts. Throw this ice away.
CUBEDIC_ CRUSHEO
I--t
The water dispenser
The water for the dispenser comes from a tank
behind the meat drawer. It holds approximately
11/2quarts (1.5 L). Dispense enough water every
week to maintain a fresh water supply in the tank.
To start the water dispenser when the refrigerator
is first hooked up, press the water dispenser bar
with a glass or jar until you draw and discard two or
three quarts (1.9 to 2.8 L). It will take one to three
minutes for water to begin dispensing. This first
water that you draw and discard will fill the tank and
pipes. Allow several hours to cool a new tankful.
To dispense water, press a sturdy glass against
the water dispenser bar. Remove the glass to stop
dispensing.
NOTE: The small tray beneath the dispenser is
designed to evaporate small drips. Do not pour
water into the tray because there is no drain in it.
\
12