Sears Refrigerator Refrigerator User Manual


 
There is interior moisture build-up
Check if ... Then ...
The air vents are blocked in the refrigerator.
The door is opened often.
Remove any objects from in front of the air vents.
Refer to page 9 for the location of air vents.
To avoid humidity build-up; try to get everything
you need out of the refrigerator at once, keep food
organized so it is easy to find, and close the door
as soon as the food is removed. (When the door is
opened, moisture from the outside air enters the
refrigerator. The more often the door is opened, the
faster moisture builds up, especially when the room
itself is very humid.)
The room is humid. It is normal for moisture to build up inside the refrig-
erator when the outside air is humid.
The food is not packaged correctly. Check that all food is securely wrapped. If neces-
sary, repackage food according to the "Food Storage
Guide" on page 26. Wipe off damp food containers
before placing in the refrigerator.
The controls are not set correctly for the surround- See "Setting the Controls" on page 8.
ing conditions.
A self defrost cycle was completed. It is normal for droplets to form on the back wall
after the refrigerator self-defrosts.
The doors will not close completely
Check if ... Then ...
Food packages are blocking the door open. Rearrange containers so that they fit more tightly and
take up less space.
The ice bin is out of position. Push the ice bin in all the way.
The pans, shelves, bins, or baskets are out Put all pans, shelves, bins, and baskets back into
of position, their correct position.
The gaskets are dirty. Clean gaskets according to the directions on page 22.
The refrigerator is not level. Level the refrigerator. Refer to "Leveling and door
alignment" on page 4.
The doors were removed during product installa- Remove and replace the doors according to the
tion and not properly replaced, removal instructions that came with your refrigerator.
Or, call for service.
The doors are difficult to open
Check if ... Then ...
The gaskets are dirty or sticky. Clean gaskets according to the directions on
page 22.
34