Filter
Top Products
The ice maker is not producing ice
Check if ... Then ...
The freezer temperature is not cold enough to See "Setting the controls" on page 8.
produce ice.
The ice maker arm is in the "OFF" (up) position. Lower arm to the "ON" (down) position. See "Using
the automatic ice maker" on page 10.
The water line shut-off valve to the refrigerator is Check to be sure the water shut-off valve is turned on
not turned on or the water line is not connected at and the water source is connected to the refrigerator.
the source. Refer to page 5 for directions. If the problem is not
due to either of the above, there may be a problem
with the water line. Call for service or a plumber.
An ice cube is jammed in the ejector arm. Remove the ice from the ejector arm with a plastic
utensil. See page 10 for ejector arm location.
The ice maker mold has no water in it or no ice Check to see if your refrigerator has been connected
has been produced, to your home water supply and the supply shut-off
valve is turned on. See "Attaching the ice maker to
a water supply" on pages 5 and 6.
There is a kink in the home water source line. If you find or suspect a kink in the water line, call for
service.
The wrong type of water shut-off valve has been Refer to page 5 for correct valve type.
installed.
The ice maker has just been installed. Wait 24 hours for full ice production to begin. Once
your refrigerator is cooled down, the ice maker
should begin producing 70-120 cubes every 24 hours.
The ice maker is producing too little ice
Check if ... Then ...
A large amount of ice has just been removed. Allow 24 hours for ice maker to restock.
The controls are not set correctly. See "Setting the controls" on page 8.
The water shut-off valve is not turned completely on. Turn valve on fully. See "Attaching the ice maker to a
water supply" on page 5.
There is a water filter installed on the refrigerator. First, check the filter installation instructions to
This filter may be clogged or installed incorrectly, ensure that the filter was installed correctly and is
not clogged. If installation or clogging is not a problem,
call for service.
There is a kink in the home water source line. If you find or suspect a kink in the water line, call for
service.
The wrong type of water shut-off valve has been Refer to page 5 for correct valve type.
installed.
3O