Filter
Top Products
13
Dimensions in parentheses are in
millimeters unless otherwise specified.
ELECTRICAL REQUIREMENTS
A 115 V AC, 60 Hz, 15 amp circuit breaker and
e
lectrical supply are required. A separate
circuit, servicing only this appliance, is
required.
The power supply cord has a 3-prong ground-
ing plug, which must be plugged into a mating
3
-prong grounding-type wall receptacle. Follow
the National Electrical Code and local codes
and ordinances when installing the receptacle.
For location of the electrical supply, refer to
the Installation Specifications illustration on
page 12.
IMPORTANT NOTE:
For Models 427 and 427R,
the electrical outlet must be placed so the
grounding prong is to the right of the thinner
blades. The outlet must be flush with the back
wall.
IMPORTANT NOTE:
A ground fault circuit
interrupter (GFCI) is not recommended and
may cause interruption of operation.
HOME ALARM SYSTEM
If a home alarm system is to be used, refer to
Other Wiring Connections on page 18. In
addition to operating power, the installer may
also be required to supply a home automation
system lead to the unit. This is for a low-
voltage, low-current signal similar to door and
window sensor signals. Common, normally
open and nor
mally closed contact configura-
tions are provided.
Three
1
/4" (6) female spade connectors are
located in the compr
essor compartment and
are accessible behind the kickplate/grille on
Models 427 and 427R. A minimum of 36" (914)
of lead wir
e should be pr
ovided for each
contact, exiting the back wall near the
electrical outlet.
UNPACKING AND MOVING
Uncrate the unit, remove its wood base and
discard the shipping bolts that hold the wood
b
ase to the bottom of the unit. Remove all
packing materials and tape.
IMPORTANT NOTE:
Do not discard the
kickplate/grille, anti-tip bracket and hardware.
T
hese items will be needed for the installation.
All roller-assembly wine shelves should be
removed to reduce weight and prevent them
from rolling. To remove, pull the shelf out to
its full extension, gently and evenly lift up on
both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
Retract the front leveling legs to allow you to
move the unit more easily during installation.
You will extend the leveling legs when the unit
is in its final position to reduce the possibility
of the unit tipping forward.
Use an appliance dolly to move the Wine
Storage unit. Position the dolly at the side of
the unit to prevent damage to finished
surfaces.
MODELS 427 AND 427R INSTALLATION
Before moving the Wine Storage unit into
position, protect any finished flooring
with appropriate materials.
Do not use an extension cord or two-
prong adapter
. Electrical ground is
required on this appliance.
MODELS
427 | 427R