Filter
Top Products
26
MODEL 430 INSTALLATION INSTRUCTIONS
GRILLE REMOVAL
In order to prevent damage to the grille and to
a
ccess the power cord, the top grille assembly
should be removed prior to moving the unit.
Framed grille:
Remove three counter-sunk
grille screws at the bottom of the grille and cut
t
he red nylon shipping strap. NOTE: Grille
screws are accessed with the door open. Then
tilt the grille forward and release the springs
from behind the grille. Refer to illustration 1
below.
Overlay panel grille:
First, remove the inner
grille panel assembly as shown in illustration 2
below. Lift up, then pull out at the bottom, pull
the top section down and out of the top key
slot. Remove the four mounting screws that
hold the outer grille panel assembly to the top
compartment. Refer to illustration 3.
ANTI-TIP
BLOCKING KIT
An anti-tip blocking kit (wood block and
hardware) is provided with the Model 430.
If there is a solid soffit above the unit with
clearance between the unit and the soffit of 1"
(25) or less, you won't need to block the unit.
For installations with clearances of more than
1" (25), you must install the anti-tip blocking
kit, to prevent tipover in case several loaded
wine shelves are extended at the same time.
Locate and mark two wall studs against the
wall where the unit will be installed. Then
locate the proper height to clear the unit. The
space between the unit top and the bottom of
the wood block must not be more than
1
/4" (6).
Position the wood block over the unit and use
the screws and ‘L‘ brackets to lock it in place.
Make sure the screws extend a minimum of
7
/8" (22) into each of the two wall studs. The
wood block must be positioned securely and
must extend at least 3" (76) over the unit. Refer
to illustration 5 on page 27.
Using the fr
ont and r
ear leveling legs, raise the
unit until it makes contact with the wood block.
See Level the Unit on page 27.
To prevent the unit from tipping forward
and provide a stable installation, the unit
must be secured in place with an anti-tip
blocking device.
Grille Springs
Grille
Screws
(inside door)
Inner Grille
Panel Assembly
1
2
3
1
2
3
Panel Grille
Frame
Soffit
1"(25)
Illus. 1
Illus. 2
Illus. 3
Illus. 4
MODEL 430