Filter
Top Products
Dimensions in parentheses are in
millimeters unless otherwise specified.4
ELECTRICAL REQUIREMENTS
A 115 V AC, 60 Hz, 15 amp circuit breaker and
electrical supply are required. A separate
c
ircuit, servicing only this appliance, is
required.
The power supply cord has a 3-prong ground-
ing plug, which must be plugged into a mating
3
-prong grounding-type wall receptacle. Follow
the National Electrical Code and local codes
and ordinances when installing the receptacle.
For location of the electrical supply, refer to the
Installation Specifications illustration on page 3.
IMPORTANT NOTE:
For Models 424 and
424FS, the electrical outlet must be placed so
the grounding prong is to the right of the
thinner blades. The outlet must be flush with
the back wall.
IMPORTANT NOTE:
A ground fault circuit
interrupter (GFCI) is not recommended and
may cause interruption of operation.
HOME ALARM SYSTEM
If a home alarm system is to be used, refer to
Home Alarm Connections on page 8. In addition
to operating power, the installer may also be
required to supply a home automation system
lead to the unit. This is for a low-voltage, low-
current signal similar to door and window
sensor signals. Common, normally open and
normally closed contact configurations ar
e
provided.
Three
1
/4" (6) female spade connectors are
located in the compr
essor compar
tment and
are accessible behind the kickplate on Models
424 and 424FS. A minimum of 36" (914) of lead
wire should be pr
ovided for each contact,
exiting the back wall near the electrical outlet.
MODELS 424 AND 424FS INSTALLATION
UNPACKING AND MOVING
Uncrate the unit, remove its wood base and
discard the shipping bolts that hold the wood
b
ase to the bottom of the unit. Remove all
packing materials and tape.
IMPORTANT NOTE:
Do not discard the
kickplate, anti-tip bracket and hardware. These
i
tems will be needed for the installation.
All roller-assembly wine shelves should be
removed to reduce weight and prevent them
from rolling. To remove, pull the shelf out to
its full extension, gently and evenly lift up on
both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
Use an appliance dolly to move the Wine
Storage unit. Position the dolly at the back of
the unit to prevent damage to finished
surfaces.
Do not use an extension cord or two-
prong adapter. Electrical ground is
required on this appliance.
Before moving the W
ine Storage unit in
to position, protect any finished flooring
with appropriate materials and secure the
door closed.
MODELS
424 | 424FS