Filter
Top Products
20
STAINLESS STEEL DOOR PANEL
Before installing the stainless steel door panel,
c
heck the panel carefully. Options are available
for kickplate/grille height, overall height, door
swing and door lock.
The stainless steel panel is mounted to the
door by passing the #8–32 x
5
/8" screws
p
rovided, through holes in the door frame
from the rear, and into the threaded holes in
the door panel. Refer to illustration 10 below.
The screw holes inside the door are hidden
under a cover flap on the door gasket. It is
necessary to lift the flap to insert the screws.
After the door panel installation is complete,
apply the cover patches or plugs provided over
the holes on the inside surface of the door.
For installation of stainless steel panels on
Model 427R drawers, see Model 427R Drawer
Panels on page 22.
OVERLAY GLASS DOOR PANEL
Inspect the door panel for the minimum
5
/8"
(
16) thickness, the greater width requirements
for the stiles (to cover the door hinges), and
the finished inside edge. The door panel has a
weight limit of 20 lbs (9 kg). See the Wine
Storage section of the Sub-Zero Design Guide
for additional panel information.
Decide if the handle will be attached through
the glass door frame or just through the deco-
rative door panel. If it is just through the door
panel, the handle must be attached first.
If a lock is to be used, the body of the lock
should be installed on the door panel after the
panel is mounted.
Decorative panels are attached to the Model
427 and 427R door using #8 x
5
/8" square drive
screws passing through the door frame from
the rear, behind the gasket into the panel. The
door panel is marked for screw locations by
the use of ‘tenon centers’, which are temporar-
ily inserted into the
1
/4" (6) diameter holes in
the front of the glass door frame. Refer to
illustration 11 below.
Door
Frame
Stainless
Steel
Panel
Back of
Stainless Steel
Panel
Door
Frame
Integrated
Panel
Tenon Center
1
/4" (6)
Diameter
13
/32" (11)
Diameter
Glass
Gasket
Illus. 10
Illus. 11
Illus. 12
MODELS 427 AND 427R INSTALLATION
The cover patches or plugs are part of the
insulation system on the door of the W
ine
Storage unit. Be sure to cover all the
holes in the door that were used.
MODELS
427 | 427R
PANEL
DESIGN
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.