Filter
Top Products
12
Model 161Operating Procedures
Step 3
Place the large o-rings into the grooves on the back of
the machine door and lubricate.
Figure 6
Step 4
Slide the front bearings over the baffle rods so the
flanged edge is against the door. P lace the white
plastic guide bearings on the end of the baf fle r ods.
Figure 7
DO NOT lubricat e the front bearings or the guide
bearings.
Step 5
Inst all the freezer door. Ins ert the handscrews into the
slots in the freez er door. With both hands, hold the
sides of th e fr eezer door and insert the baffle rods into
the center of the beater assemblies. The white guide
bearings must fit securely i n the holes of the drive
shafts. Finger -tighten the handscrews equally to
insure that the door is snug. Do not over-tighten.
Figure 8
Note: The fr eezer door is in the correct position when
the door spouts are on the bottom.
Step 6
Slide the two o-rings into the grooves on the draw
valves and lubricate.
Figure 9
Step 7
Install the valve seal in the grooves on the cent er draw
valve and lubric ate. This s pecial seal will prevent mix
from one freezing cylinder from traveling into the
second cylinder.
Figure 10