Filter
Top Products
17
Model 161 Operating Procedures
Draining Product From the
Freezing Cylinder
Step 1
Press the AUTO key to cancel operation. Press the
MIX REF key to cancel hopper refrigeration. These
operations should be cancelled as far ahead of
cleaning time as possible. This will allow frozen
product to soften for easier c leaning.
Note: Non--Softecht machines: Place the power
switch in the OFF position as far ahead of cleaning
time as possible. This will allow f rozen product to
softe n for easier cleaning.
Step 2
Lift the hopper cover . Remove the air tube and mix
level float. Take them to the sink for cleaning.
Step 3
With a sanitized pail beneath the door spouts, place
the power switch in the WA SH position and open the
draw valves. When all the product stops flowing from
the door spouts, close the draw valves and plac e the
power switch in the OFF position. If local health codes
permit, empty the rerun into a sanitized stainless steel
rerun can. Cover the cont ainer and place it in t he
walk-in cooler.
Repeat Steps 1 through 3 for the second freezing
cylinder.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Rinsing
Step 1
Pour onegallon (3.8liters)of cool, clean water intothe
mix hopper. With the brushes provided, scrub t he mix
hopper, and the mix inlet hole.
Note: Non--Softecht machines: Scrub the mix
level float stem.
Step 2
With a pail beneath the door spouts , press t he WASH
key and open the d raw valves.
Note: Non--Softecht machines: Place the power
switch in the WASH position.
Step 3
Drain all the rinse water from the freezing cylinder.
When the rins e water stops flowing from the door
spout, close the draw valves and press the WASH key
to cancel.
Note: Non--Softecht machines: Place the power
switch in the OFF pos ition to cancel.
Repeat this procedure until the rinse water being
drawn from the f reezing c ylinder is clear.
Repeat Steps 1 through 3 for the second freezing
cylinder.
Cleaning
Step 1
Prepareone gallon (3.8liters ) of an approved cleaning
solution (example: Kay-5r). USE WARM WATER
AND FOLLOW THE MANUFACTURER’S SPECIFI-
CATIONS.
Step 2
Pour the one gallon (3.8 liters ) of cleaning soluti on into
the mix hopper and allow it to flow into the freezing
cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush-clean the mix hopper, mix level float st em and
mix inlet hole.
Step 4
Press the WASH key. This will cause the cleaning
solution in t he fr eezing cylinder to agitate.
Note: Non--Softecht machines: Place the power
switch in the WASH position.
Step 5
Place an empty pailbeneaththe door spouts and raise
the draw valve. Draw off all the cleaning solution.
When the solution stops flowing from the door spouts,
close the draw valves. Press the WASH key to cancel.
Note: Non--Softecht machines: Place the power
switch in the OFF pos ition to cancel.
Repeat Steps 1 through 5 for the other side of the
machine.