Filter
Top Products
22
Model 161Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
4. The product is t oo soft. a. The control i s set too
warm.
a. Contact service
technician.
10
b. The a ir t ube is not
installed.
b. Install the air t ube in the
mix inlet hole at the
bottom o f the mix hopper.
15
c. Out-dr awing the freezer’s
capacity.
c. Two 4 oz. (113.4 gram)
servings in one minute.
---
5. The freezing cylinder walls
are scored.
a. Operating freezer without
the front bearing on the
freezer door.
a. In stall the front bear ing on
the freezer door.
12
b. Th e gear unit o r t he direct
drive is out of alignment.
b. Contact service
technician.
---
6. Excessive leakage in rear
drip pan.
a. A worn o r def ective o-ring
is on the beater drive
shaft.
a. Replace o-rings every 3
months.
24
b. Th e rear shell bearing is
worn.
b. Contact service
technician.
---
c. Incorrect lubricant was
used.
c. Use food grade lubricant
(example: Taylor Lube).
11
d. Inadequate lubric ation of
beater drive shaft.
d. Lubric ate the beater drive
shaft properly.
11
7. The draw valve is leaking. a. Incorrect lubricant was
used.
a. Use food grade lubricant
(example: Taylor Lube).
12
b. Worn or defective o-rings
are on the draw valve.
b. Replace o-rings every 3
months.
24
c. Inadequate lubrication of
draw valve.
c. Lubricate the draw valve
properly.
12
8. Product is not feeding into
the freezing cylinder.
a. The mix level i s
inadequate in the mix
hopper.
a. Fill the mix hopper with
mix.
15
b. The mix inlet hole is
frozen.
b. Contact service
technician.
10