Filter
Top Products
English 16
Installing Grease Trays, Filters and
Spacers
1. Remove all plastic from hood pieces.
2. Insert in the following order:
1) Grease Tray — Push up and in over the rear lip.
2) Filters —
Slide filter over the front lip. Push filter
rear up, then slide back over rear lip.
Depending
upon the size and model of hood, there will be from
1 to 3 filters per hood.
3) Filter Spacer — Insert these the same way as the
filters.
3. Reverse the above directions to remove the grease
tray, filters and filter spacer (Figure 26).
Note:
Do not use cooktop while hood is disassembled. Grease
trays must be in place before installing the filters.
Heat Lamp Replacement (some models)
• Turn heat lamp clockwise to install (Figure 27).
• Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
Refer to the Use and Care Guide for additional information.
Halogen Light Replacement
1. Using a flat edge from a screwdriver or equivalent tool,
pry loose the lens cover, as shown in Figure 28.
2. Pull damaged bulb straight out from the socket to
remove.
3. Replace with a new 120 V, 40W (maximum) bulb with
G-9 base. Press pins in bulb base straight into socket
until fully seated. Follow package directions and do not
touch new light with bare hands, the oils from your skin
can reduce the longevity of the bulb.
4. Reinstall the light and cover.
Figure 26: Hood and Parts
Filter
Spacer
Filters
Grease
Tray
1
2
2
1
Filter
Space
r
Data Rating
Plate
Figure 27: Heat Lamp Replacement
Figure 28: Halogen Light Replacement
Bulb
Lens