Thermador PH30HS Ventilation Hood User Manual


 
English 2
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Grounding Instructions:
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
Be sure your appliance is properly installed and grounded
by a qualified technician. Installation, electrical connections
and grounding must comply with all applicable codes.
WARNING – TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK AND INJURY TO PERSONS
OBSERVE THE FOLLOWING:
This ventilator assembly must be installed with
THERMADOR
®
recommended blowers only. Contact
Customer Service for additional options.
Use this unit only in the manner intended by the
manufacturer. If you have questions, contact Customer
Service at 1-800-735-4328.
Before servicing or cleaning unit, switch power OFF at
service panel and lock the service disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
To properly exhaust air, be sure to duct air outside. Do
not vent exhaust air into spaces within walls, ceilings,
attics, crawl spaces or garages.
Before you plug in an electrical cord, be sure all
controls are in the OFF position.
WARNING:
Improper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding
instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
WARNING:
To Reduce The Risk Of Fire Or Electric Shock
Do not use this fan with any solid-state speed control
devices.
WARNING:
Halogen lights and heat lamps might be hot.
Disconnect from power and allow to cool
before servicing.
WARNING:
Local building codes may require the use of make-up air
systems when using ducted ventilation systems greater
than specified CFM of air movement. The specified CFM
varies from locale to locale. Consult your HVAC
professional for specific requirements in your area.
CAUTION:
For general ventilating use only. DO NOT use to exhaust
hazardous or explosive materials or vapors.