Filter
Top Products
English 6
Electrical Requirements
The unit requires a 120V AC, 60Hz. 15A branch circuit. The
VTR1330E blower in conjunction with a 27" Pro Hood
requires a 20 amp circuit breaker.
The hood should only be connected to a dedicated circuit
(with ground) that has been installed according to relevant
regulations.
When connected to a GFCI-protected supply,
THERMADOR PROFESSIONAL
®
hoods are suitable for
use in damp locations that are protected from outside
weather conditions and not subject to saturation with water
and other liquids, but can be subject to moderate degrees
of moisture (such as an outdoor covered patio or lanai
area). Refer to local codes, NEC/CEC, and or the Authority
Having Jurisdiction (AHJ) for additional information.
Check your local building codes for proper method of
installation. In the U.S., if there are no applicable local
codes, this unit should be installed in accordance with the
National Electric Code ANSI/NFPA No. 70, Current Issue.
In Canada, installation must be in accordance with the CAN
1- B149.1 and .2 - Installation Codes for Gas Burning
Appliances and/or local codes.
The appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric
shock by providing a wire that allows the electric current to
escape.
Electrical Data on the Data Rating Plate:
Data, including the model and serial number, is located on
the product data rating plate inside the appliance, visible
after removal of the filter frame (see Figure 26 on page 16).
Hood Preparation
Note:
Optional stainless steel backsplashes are available in
widths to match all pro wall hoods. Before installing the
hood, the backsplash should be installed first. See
directions accompanying the backsplash for full installation
instructions.
Discharge Direction:
The hood can be mounted on a wall or suspended from a
cabinet. Both vertical and horizontal discharge are possible
with either mounting method.
The hood is shipped ready for vertical discharge. To
change to horizontal discharge, move the discharge cover
shown in Figure 2 to the top of the hood. The plate is held
in place by (4) screws.
WARNING:
The appliance must be grounded.
Figure 2: Discharge Direction
This opening
is covered for
horizontal
discharge
This opening
is covered for
vertical
discharge