Filter
Top Products
PREPARATION PRIOR TO OPERATION (continued)
10
Examine the CRADLE ROLLERS. Adjust or tighten as required.
Lubricate the rollers with vegetable oil.
DO NOT operate the fryer unless CRADLE ROLLERS are in place
and rotating freely.
Install LIFT CRADLE onto CRADLE PIVOT. Set FRY BASKET on
LIFT CRADLE.
Install FILTER LEAF into FILTER RESERVOIR.
SUCTION TUBE O-RINGS are shipped from the factory installed on
SUCTION TUBE; Examine to verify one O-RING is in the groove
closest to the end of the tube.
Install assembled FILTER RESERVOIR into fryer. O-RING for the
filter reservoir suction tube, and up to three spare O-RINGS, are
stored as shown above.
IMPORTANT:
Serious damage to the frypot
will result if the rollers are
missing or do not rotate freely.
RETAINING NUT
ROLLER
LIFT CRADLE
PIVOT
LIFT ROD
STORAGE FOR 3
SPARE “O” RINGS
“O” RING IN
“O” RING GROOVE
ASSEMBLED FILTER LEAF
(spout with O-RING inserts
into drain opening)
FILTER
RESERVOIR
RESERVOIR
ASSEMBLY
CROSS-SECTION VIEW
“O” RING
FILTER RAIL “A”
FILTER RAIL “B”
UPPER
FILTER SCREEN
LOWER
FILTER SCREEN
SEPARATOR
SPARE
“O” RINGS
Note: “O” RING
371 301098 OpManual for WFGA-60FS Gas Fryer
Fig. 5 Lift Cradle Assembly
Fig. 6 Filter Reservoir Assembly