Filter
Top Products
OPERATION - OPTIONAL FILTER WAND (continued)
20
371 301098 OpManual for WFGA-60FS Gas Fryer
USING THE OIL WAND - WASH OUT FRYPOT or DISCARD OIL
1. If discarding oil, be sure a suitable hot oil disposal container
is available. Otherwise, prepare the filter reservoir pan for
filtering.
2. Turn the DRAIN VALVE HANDLE down to open the drain and
fill the filter reservoir.
3. Insert the wand fitting into the fryer fitting:
a. Slide the locking ring of the wand fitting fully toward the
hose.
b. Insert the wand fitting fully into the fryer fitting.
c. Allow the locking ring to spring forward.
d. Check to verify that the wand fitting is held securely by
pulling on the hose.
4. Turn the 3-WAY VALVE HANDLE clockwise to the front-to-rear
position to direct the pump output to the oil wand.
5. Direct the discharge nozzle of the oil wand into the frypot, or
into a suitable hot oil disposal container. DO NOT fill beyond
the MAX OIL line.
6. Press the FRYER-OFF-FILTER switch to the FILTER position.
7. Wand may be used to wash down the sides of the frypot during
filtering, or to pump oil into a container for disposal.
8. At conclusion of use, press the FRYER-OFF-FILTER switch to
the OFF position, disconnect wand from fryer fitting and return
the handle of the 3-way valve to the left-right position.
9. Drain any remaining oil in the wand by pointing the discharge
nozzle of the wand down into the frypot or disposal container.
DANGER:
BURN HAZARD
Contact with hot oil will cause
severe burns.
Always wear protective clothing
and heat resistant gloves when
using the oil wand.
IMPORTANT:
Be sure the wand is properly
installed, and that the discharge
nozzle of the oil wand is directed
either into the frypot, or into a
suitable hot oil disposal container,
before pressing the
FRYER-OFF-
FILTER
switch to the FILTER
position.
CAUTION:
BURN HAZARD
Contact with hot oil may cause
burns. DO NOT fill fryer beyond
MAX OIL line on frypot.
For disposal of oil, use only a
container specifically designed
for the disposal of hot
oil.
DO NOT fill hot oil disposal
container beyond MAX OIL line.
NOTE:
If the discharge from the nozzle is
not a steady stream, the filter is
clogged with breading and/or filter
powder:
a. Close the frypot drain valve
by turning the drain valve
handle to the up position.
When all oil is returned to
the frypot press the
FRYER-OFF-FILTER switch
to OFF.
b. Allow the filter reservoir to
cool. Refer to the Operation
Manual for instructions on
cleaning the filter and filter
reservoir.