Filter
Top Products
29
371 301098 OpManual for WFGA-60FS Gas Fryer
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Fryer will not heat
Unit disconnected from electric power
Reconnect to power
Check/reset circuit breaker
Menu temp not programmed or set too
low
Press TEMP key to check current
temperature. Program menu key for
desired temperature as required
Hi-Limit thermostat (item 9) tripped
Allow unit to cool, reset hi-limit
See page 3
Fryer in CLEAN mode
(Display reads BOIL)
Press power switch OFF, wait 10
seconds, press power switch to FRYER
Fryer in STANDBY mode
Press STANDBY key for three seconds
(beep will sound). Press and release
MENU key to resume cooking.
Internal damage
Contact your Authorized Wells Service
Agency for repairs
Burners won’t light, or “pop” when igniting
GAS SHUT-OFF VALVE(S) not fully ON
Verify that gas shut-off valves are in full
open position
Gas pressure not correct
Verify that gas pressure regulators are
are adjusted to the recommended
pressure.
MUST BE PERFORMED BY A
QUALIFIED TECHNICIAN.
Internal damage or internal component
mis-adjusted
Contact your Authorized Wells Service
Agency for repairs
Lift cradle will not lower
Menu key not programmed for time, or
programmed to 00:00
Program menu key for desired time.
Be sure to press BASKET + DOWN to
lower basket.
Internal damage or mis-adjustment
Contact your Authorized Wells Service
Agency for repairs
PAUSE pressed
Be sure to press BASKET + DOWN to
lower basket. Press PAUSE when
basket is down to resume
Lift cradle will not raise
Lift cradle not properly assembled to lift
rod
Properly assemble cradle pivot to lift rod
Internal damage or mis-adjustment
Contact your Authorized Wells Service
Agency for repairs
NOTE: There are no user serviceable
components in the fryer. In all cases of
damage or malfunction, contact your
Authorized Wells Service Agency for
repairs.
CONTINUED ON PAGE 30
Drain not fully closed (filter wand option)
Be sure drain handle is fully closed
(drain safety switch made).