A-5
Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2
78-19417-01
Appendix A Specifications
Card Specifications
–
12 inches (20.5 cm) without cables installed
–
13.7 inches (34.8 cm) with cables installed
• Weight:
–
25 lbs. (11.3 kg) maximum (line cards, fan-tray assembly, and two electrical interface
assemblies (EIAs) installed)
A.2 Card Specifications
This section provides specifications for the 15310-MA SDH electrical and 15310E-CTX-K9 cards. For
compliance information, refer to the Cisco Optical Transport Products Safety and Compliance
Information document.
A.2.1 15310E-CTX-K9 Card
The 15310E-CTX-K9 card is installed in Slots 3 and 4 of the ONS 15310-MA SDH only. The
15310E-CTX-K9 has the following specifications.
• LAN Port
–
Supports a 10/100-Mbps Ethernet interface for Cisco Transport Controller/Transaction
Language One (CTC/TL1) provisioning.
–
For node access in secure mode, SSL (for TL1) and HTTPS (for CTC) security protocols are
supported.
• CRAFT Port
–
An EIA/TIA-232 craft interface is provided and is used for TL1 provisioning.
–
The craft interface is set to 9600 baud, no parity, and 1 stop bit by default.
• Nonvolatile memory
–
128 MB, Compact Flash card
• Optical ports: Line
–
Bit rate: STM1 (155.520 Mbps), STM4, (622.080 Mbps), and STM16 (2488.320 Mbps),
depending on the SFP installed
Note Both optical interfaces on the card can be configured as STM1, STM4, or STM16.
–
Code: Scrambled NRZ
–
Fiber: depends on the SFP used
(see the “A.3 SFP Specifications” section on page A-9)
–
Loopback modes: Terminal and facility
–
Connectors: LC duplex connector for each SFP
–
Compliance: ITU-T G.707, ITU-T G.957
• Optical ports: Transmitter
–
Maximum transmitter output power: Depends on the SFP used
(see the “A.3 SFP Specifications” section on page A-9)
