Filter
Top Products
8 COREBUILDER 6000 INTELLIGENT SWITCHING SOFTWARE REVISION 8.2.0
3 At the command line in the Setup dialog box, enter a:setup and click OK.
A Welcome screen appears. The system prompts you to continue or to
cancel the installation. To continue, click Next. To cancel the installation and
exit the Setup program, click Cancel.
You are guided through the rest of the installation procedure by the Install
Shield Wizard.
This procedure creates a file folder called
lp6000, which contains:
■ IMAGE folder
■ MIBS folder
■ README.text
Loading System
Software on
the LMM+
Before loading the system software on the LMM+, verify that the host
computer, which has a copy of the updated system software, is connected
to the CoreBuilder 6000 system.
You can load the system software into flash memory while the system is
operating. You do not need to bring the system down. After the flash install
is completed, a quick reboot puts the newly loaded software to use.
If you are loading software from a PC host, the FTP server software must be
running on the PC before you begin this procedure.
Loading 8.2.0 software into flash memory takes approximately 10 to 15
minutes to complete, depending on your network load.
To load the new software:
1 From the top level of the Administration Console, enter:
system softwareUpdate
The system prompts you for the Host IP address, Install file name, User
name, and Password. The current default values are displayed in brackets [
]. Press [Return] to accept the default values. The Password field does not
display what you enter.
2 Next to
Host IP address, enter the IP address of the host machine (such as
a Sun workstation or PC) from which you are installing the software.
In the example in step 5, the IP address of the host is
192.9.200.96.