Filter
Top Products
24 COREBUILDER 6000 INTELLIGENT SWITCHING SOFTWARE REVISION 8.2.0
■ You cannot modify the port specification of an IP interface defined on the
LMM+ module. To modify the port specification, remove the IP interface
and define it again.
■ When you install software using the SNMP lpsFt MIB, the installation fails
unless you specify a user password.
■ When you install software from an unreachable device using the SNMP lpsFt
MIB, the system reports the incorrect status “statusFileNotFound”, rather than
the correct status “statusRemoteUnreachable”.
■ When you install software using the SNMP lpsFt MIB and you specify an
invalid username and password pair, the system reports the incorrect status
”statusFileNotFound”, rather than the correct status “statusUserAuthFailed”.
■ ESM Arp table displays invalid hardware address.